SetSeriesVisible not working for BarRenderer/BarRenderer3D

Krac · Post by **Krac** » Fri Jan 18, 2008 1:11 pm

Hello, everyone.

Is there any workout for SetSeriesVisible for the mentioned renderers (Bar&Bar3D)?

I use

setSeriesVisible(series, BooleanUtilities.valueOf(b));

in order to make the desired series apper/disappear, but without any effect.

This works though for LineAndShapeRenderer.

Any directions would be highly appreciated.

TIA, all the best

Post by **david.gilbert** » Fri Jan 18, 2008 1:20 pm

I think this didn't get implemented yet, because it adds the complication of redistributing the remaining bars across the category space. It needs doing though...I've just been lazy!

Krac · Post by **Krac** » Fri Jan 18, 2008 1:32 pm

Dave, what if the remaining space isn't redistributed? Maybe this would be a simpler workout.

The same works for LineAndShapeRenderer, WITHOUT redistributing the remaining empty space!

Krac · Post by **Krac** » Fri Jan 18, 2008 1:43 pm

I've found a workout on this subject -unfortunatelly it is for StackedBarRenderer3D

- at the following address:

http://sourceforge.net/tracker/index.ph ... tid=115494

I wonder if that can help for BarRenderer & BarRenderer3D.